Bedroom Door Won T Latch Closed

Try applying wd 40 or a silicone lubricant if the latch is still catching in the door.

Bedroom door won t latch closed.

If not do the lipstick test smear lipstick on the latch and stick masking tape to the strike plate. Again start by tightening the screws and see if this helps. Step 3 align strike plate. Even if your door has been binding for years we ll show you how to identify the problem and repair it quickly and inexpensively.

The idea is that for a door to latch properly the latch bolt must make its. How to adjust a doorknob so that it will stay shut. Doors that won t shut or latch properly are annoying but once you diagnose the problem the fix is usually easy. Remove the loose screw and drive a no.

When the doorknob doesn t latch completely and the door won t stay closed the fault usually isn t with the knob but with the strike plate. If this is the case the door may pull open even when closed or may grind against the latch strike plate. When a door latch won t catch it s because the latch doesn t align with the hole in the strike plate. In this video rob shows 3 simple ways to fix a door that won t shut.

Therefore you need to know how to fix a door latch. The latch bolt slides through a hole in a flat piece of metal called a strike plate that is attached to and covering a hole in the door jamb. Close the door and check to see if the strike plate is too high or too low. This bolt is called a latch bolt fitting since its job is to latch a door closed and unlatch a door to enable opening it.

Subscribe for free diy fun tips for maintenance at your place. If the door still does not latch properly then it could be that the strike plate is not aligning properly with the latch. When an interior door won t stay. Follow rob on facebook.

A faulty interior door latch can also be the cause of an interior door not closing properly. How to fix a bedroom door that won t latch. I could surely stop here as other people in my house can now close this door but no that just won t do. December 20 2011 by mark russo 2 comments.